![]() ![]() To reset your light you must keep power off of it at least 20 minutes. Another possibility is it may need to be reset, sometimes you can hit the switch three times it will stay on that should not cause the photo sensor not to work. The light then hit the photo cell of the next light and a domino effect happened which caused the next three lights not to work. If your sensor light only works in test mode and when you turn it to minute mode the red light flashes and the light does not turn on heres the problem, more than likely it is receiving light from somewhere else and for the gentleman that had four lines hooked up and one worked properly and the other three are doing the same thing as the problem above then the circuit hit the light that came on first. I love my job and I want to be the best I can be, especially when I'm having the same problem. Any question that is about lighting its best to figure out the answer. I have worked with lighting for many of years. OK I'm a smart ass female that works at a very known chain improvement store.
0 Comments
Leave a Reply. |